This is another asphalt roofing project by AC Roof Repair in Revere, MA. Installing partial rolled roofing involves specific steps for a localized repair or addition.
1. Prepare the Area:
– Clear the area of any debris or dirt.
– Ensure the existing roof surface is clean and in good condition.
2. Measure and Cut:
– Measure the area where you’re installing the partial rolled roofing.
– Cut the rolled roofing material to fit the measured space using a utility knife.
3. Apply Adhesive:
– Use roofing adhesive appropriate for your roofing material.
– Apply the adhesive to the underside of the rolled roofing and to the area where it will be installed.
4. Install Rolled Roofing:
– Carefully place the rolled roofing onto the prepared surface, aligning it correctly.
– Smooth out any wrinkles or bubbles.
5. Secure Edges:
– Secure the edges of the rolled roofing using roofing nails or other appropriate fasteners.
– Ensure a tight seal around the edges to prevent water infiltration.
6. Overlap Seams:
– If you’re installing multiple pieces, make sure to overlap seams according to the manufacturer’s instructions.
– Apply additional adhesive to seal the seams.
7. Inspect and Seal:
– Inspect the installed roofing for any gaps or loose areas.
– Seal any exposed edges or seams with roofing adhesive.
8. Finish:
– Trim any excess material using a utility knife.
– Install flashing around the edges if necessary.
